walking crank
, enjoy (was taken from the dsm board)
Funny yea, cute no. Admit it, 2g 4g63s suck..the oiling system isnt up to par like the earlier 1g 6-bolts..AND 7-bolts. 7 bolts upto 94 are fine...95-99 are right offs. ...EVEN THOUGH Evos with 95-99motors are fine and haul'd *** and spin faster. Why? Built in Japan by staff that care..not your neibour Linda that gives two s about seating the crank against the thrust bearing 
GTcars Regular
Joined: Feb 2005
Posts: 1,437
From: Brampton
Rep Power: 0 
To liven up this thread...some other uses for 7M engines a.k.a. rod knock king. These bearings were taken out of the block that came with my car when I bought it:
What happened to that block:
What happened to that block:
GTcars Regular
Joined: Feb 2005
Posts: 1,437
From: Brampton
Rep Power: 0
Originally Posted by B6T
Adam thats a gorgeous table until you put a cup of 100 degree coffee on the edge and the glass tilts and spills that hot coffee on your ball sack.
Experienced GTcars Poster
Joined: Feb 2005
Posts: 1,518
From: Mississauga
Rep Power: 807 
Originally Posted by blackout_89t
Yea I know. That is an old pic. I dont even use the damn thing its tucked away in a closet somewhere. I have been meaning to have the rods welded to the cylinder walls on an angle offset from one another to give a bit more support.
I want to make a table like that... but it would so small people wouldn't see it and trip over it.