Whole New System in a Maxima
 

Hey guys, Alright i have a couple questions with installation.

This is my setup:

Subs:
POLK AUDIO DB212
http://www.polkaudio.com/caraudio/products/db212/
Overall Frequency Response 20Hz-200Hz
Nominal Impedance 2 ohms
Power Handling (continuous) 720 w
Power Handling (peak) 1500 w
Efficiency 103 dB

Speakers:
4x ALPINE SPR-17C
http://www.alpine-usa.com/US-en/products/product.php?model=SPR-17C
General
• Sensitivity: 87dB / W(1m)
• Impedence: 4 Ohms
• Frequency Response: 65Hz - 27kHz
Power Handling
• Power Handling Capacity (Peak): 300 Watts
• Power Handling Capacity (RMS): 100 Watts
• CEA-2031 Power Rating: 100 Watts

Head Unit:
Pioneer 5900IB with Ipod Control
Pretty self explanatory lol.

Amp for speakers MTX TC4004

» 4-channel car amplifier
» 50 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
» 200 watts RMS x 2 in bridged mode (4-ohm stable in bridged mode)
» each amp is tested and certified to produce 10% more power than listed
» variable high-pass/low-pass filters (40-350 Hz, 12 dB/octave)
» variable Thunder EQ bass boost with wired remote control (0-18 dB at 40 Hz)
» preamp-level inputs
» speaker-level inputs with Smart Engage
» N-Channel technology for efficient power output

Amp for Subs KENWOOD KAC-9104D Class-D MONO 1800w
Amplifier Class : Class D
Number of Channels : 1-Channel
Maximum Power : 1800 Watts
RMS Power Output @ 4 Ohms : 500 Watts x 1-Channel
RMS Power Output @ 2 Ohms : 900 Watts x 1 Channel
Bridged Power : N/A
THD : 1%
Signal-to-Noise Ratio (dB) : 100dB
Frequency Response (Hz) : 20Hz~200Hz
Built-in Crossover : N/A
High-Pass Crossover Frequency : N/A
Low-Pass Crossover Frequency : 50Hz~200Hz
Bass Boost : 0dB~18dB
Bass Remote : N/A
Fan Cooled : Yes
Fuse Rating : 30A x 2

Wiring

I have been told that one run of 0gauge wire will power my system. Now with one 0gauge amp wiring kit can I wire both of my amps or will I need TWO amp wiring kits? I also have 60ft of Monster Car audio speaker cable to wire the Alpine Speakers.

1 0ga kit, and then just get a distribution block to wire up the amps.

I am running a similar setup and I am running only 4 gauge power wire. and I have no problems. My only recommendation is get yourself a capacitor (1 farat) - at least

That's sweeet. What was your total price?

haha, well i still need to buy the amp for the subs and the 0 gauge amp kit. Nothing is installed, ive been loafting.

So far its been about $500, I got everything discounted off ebay :)

thats a pretty good deal...if you ask me i would of used a different amp for the subs..
give em a bit more SQ oriented amp

hmm what would you recommend? I want to run around 1000-1300watts to the subs.

oh and i put in the alpine type r's this weekend, they sound amazing.