LS VTEC Fully Built Motor in 93 Bubble
 

crossed drilled breaks all the way around'
car is red with very little rust on driver side quarter panel
full 2 1/4 exhaust
skunk 2 coil overs
13inch rims
stock looking car....

motor is a b162gen jdm with everything done to it
port & polish valves, retainers, sprinings, cat cams stage 2, edlbroke intake, fuel presure reg, fuel pump 255 walbro, 355cc injecters, str fuel rail, str cam gears.....

bottom end is a LS b18b bored out, je pistons, eagle rods, block guard, new water pump, timeing belt,p28 chiped ecu, type r tranny no grinds mint stage 3 clutch with 8lb fly wheel, avid racing drive shafts

motor has about 5000km on it dyno tuned at 188hp at the wheel with 145ftq motor is still fresh for the summer asking 5500$

call 905-484-0790 ask for manny if u want to go for test drive or pm me

http://www.jonclosedesigns.com/ebay/nibbs/pic1.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic2.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic3.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic4.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic5.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic6.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic7.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic8.jpg

http://www.jonclosedesigns.com/ebay/nibbs/pic9.jpg

are you open to any trades?

who built the motor?

its a stock ZC

location
 

Where are you located?

im located in barrie

pm'd you