Rep Power: 735

hi , i just put some dropzone 1 3/4 drop spring today but the rear spring are very small and they move easily when the car is in the air and are hard to center cause they move very easily...so now i think the car sit lower on one side. do i have to put special plate/bushing under the spring to stop them to move...plus the front spring are so uge that they are 2x bigger than the stock spring ... and i cant put them on cause the dish on the strut are to smal for the spring i have a v6 camaro 1996:banghead:
need help thanks

 
Rep Power: 954

Are you sure they sent you the right springs?

 
Rep Power: 768

Yeah,...double and triple check the part# with this Dropzone to make sure they are for your car, and also for a V6. I just finshed with some pretty detailed instructions in the PM, so make sure you check all those things, and have a second or even a third person there to help guide the rear springs as you let the car down.

If you arn't changing the shocks, relocation brackets and adj. panhard bar, you will certainly have problems with lowering it that much. As I mentioned, I used 1.5" springs on mine and it dropped 2 full inches. So if you're only doing springs right now, I would "HIGHLY" Recommend waiting till you can change the other things all at one.

 
Rep Power: 735

yeh...i am still waiting for a reaply from dropzone!! and i will hve to change the shock and put some adjustable LCA so everything gona be centre i hope i can change them
thanks

 
Rep Power: 870

did you switch the front and the back around?

 
Rep Power: 881

I would hope not since they are twice the diameter..it should be pretty obvious which ones go where...