Valve Covers
 

How hard are they to get off? I'd like to add some bling..... or somethign to the engine bay, Im thinking paint them, whats y'alls opinion.

Shouldnt be too hard but I dont know for sure. Never got that deep into my 6 when I had her. All I know is an LT1's aren't that bad.

there kind of a *****.. i pulled mine when i pulled the intake manis so i was already deep off into the motor.. i had to pull the fuel rails the coil packs etc.. it sucked but its really just a matter of time

3.4 they suck to take them off

On the 3.8, you have to take off the coil pack, fuel rails, fuel lines, and a few other little odds and ends. Will take about an hour or so.

Hmmmmm, maybe ill wait on this until I get a few days in a row off from work, incase I run into problems, which with my luck, i deffinatly will. Do you guys think 500* temp paint would hold up, or would it end up looking like crap a while down the road.

eh i am using 1200* temp paint on all of my stuff (brake calipers) valves covers etc.. but 500* should work..

my only advice is get a haynes manual and make sure you know how to paint well

i would just use the highest temp u can get in the color u want cause it wont hurt to be able to handle more heat than u want, and good plan with the couple days thing shouldnt take u that wrong but u know nothing ever goes excatly like it should