DA integra interior in an EF civic?
 

Does anybody know if older integra interior (90-92ish) will fit in an 88-91 civic? I am so bored of my EF interior, and would like something different. If anybody has any ideas...let me know

the ef si seats are the best fitting seats by far for the ef. I find other seats not as sporty or mounted as low.

i read about this mod you can do for the centre console on HT
get a centre console from a 94+ integra and it shud fit almost exactly where your old ef centre console fits, you'll need 2 screws to screw it in place, this require little to no modding/ fabricating at all and as a bonus, you get an armrest and a cup holder.

cheers

a DA dash would look sick in an EF

only 3 of the 4 seat brackets from a DA seat will line up. rear seat, not even close. none of the latches and bolt holes will line up. as for the dash i'm not too sure. i have a dash that you could try it out with. if it's still in decent shape you can have it, you just gotta pull it. i also know some one that had a couple he was trying to unload. when he get's back in town i'll ask him.

That would be awesome man... pmd u.

Da dash in an ef has been done and it looks wicked. I know in my friends 4 door ef he tried mounting da seats in and only 3 of the 4 mounting bolts lined up, but i don;t think it works for any year ef because the dA integras mount there seat 90 to the right at one corner instead of all 90 to the floor.

You will need all the brackets, harness, cluster for the Da dash to work and like anything will take some improvising.

cool, but how hard is it to customize? i doubt all of the wiring e.g. heater controls, cluster, etc.. are exactly the same...then again it is a honda :)

no their definatly not the same, but take a look on hondatech, Iv seen a few cars that have done it. It actually doesnt look all that bad at all, and aside from the wiring and all that the hardest parts is making the DA brackets work on the car, as the ef brackets will be no good. on HT theirs a guy who has the brackets and sells them, find him, he can no doubt give you an idea on how its done. Post some pictures up if you end up doing it

da swap
 

Swapping a Da dash in an Ef is a perfect entry level dash coversion if your looking to earn yourself... wiring,mesuring,templates,cutting & possible welding are involved with dash conversions.

earn myself? why would i need to earn myself?

what a waste of time =) they look the same and work the same
you can fit a DA cluster into a EF =)

R u retarded? why do stupid people act like they are smart?........

honestly i dont think the dash itself looks any better then a crx dash, and hes right, you could just swap the clusters. but better yet why not just swap and ek ctr cluster into it