H22 crankshaft mains install problem ?
Thread Starter
~~ Hardcore Newb ~~
Joined: Sep 2008
Posts: 1
Rep Power: 0 
H22 crankshaft mains install problem ?
I recently built my h22 honda. I believe I overtorqued the main bearings after thinking about it. I was extremely cautious in building the engine but looking back at it i think I thought the torque spec was 80 ft lbs when they are truly at 54 ft lbs. The engine runs fine and has over 2k on it with no issues and the crankshaft turns fine. If i did overtorque them main bolts would it still be running well and turn easily ? How bad is this ? Could I retorque the bolts while in the car or is the weight of the crank on it going to make this difficult.
~~ Hardcore Newb ~~
Joined: Sep 2008
Posts: 1
Rep Power: 0
Hi mate it looks like I searched best answer to ur yahoo question. You might want to try below link. Let me know if you can find the answer by searching at below link.
snipurl.com
snipurl.com
Thread
Thread Starter
Forum
Replies
Last Post
Jennifer D
Honda Civic - Del Sol - CRX
0
Jul 9, 2008 01:32 PM
96SilverRam
Car Care / Detailing / Paint / Visual Mods
10
Oct 25, 2007 10:58 PM
aliyev
Honda Mailing List
3
Sep 10, 2003 11:51 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)