GTcarz - Automotive forums for cars & trucks.

GTcarz - Automotive forums for cars & trucks. (https://www.gtcarz.com/)
-   Honda Mailing List (https://www.gtcarz.com/honda-mailing-list-327/)
-   -   2001 Accord: Stalls during stop (https://www.gtcarz.com/honda-mailing-list-327/2001-accord-stalls-during-stop-289400/)

Alan Browne 09-24-2005 05:29 PM

2001 Accord: Stalls during stop
 
My Accord (2 door, 4 cyl, 2001, manual, 65,000 Km) engine occasionally
just stops as I press the clutch to the floor (while coming to a stop).
This is happening about 1 in 20 stops; sometimes two or three times in
a row and then doesn't occur for a few days. In any other state,
behaves perfectly, accerated briskly and cruised without fault.

For example coming up to a stop/light I'm downshifting and compressing
and as it comes to final rest, the RPM just decays right to 0. (Cluth
all the way in). Occasionally, the RPM will go right down to 0 and then
come up to 500 - 750 by itself, but usually the engine stops.

Sometimes the car will idle at 500 instead of the more normal 750-1000
range. During this low idle speed the engine will occasionally
"tremble". Sometimes it will recover to 500 RPM after this, but usually
just sits at 500 unless I give it a little gas.

Car always starts without fault or delay, so sometimes if it stalls even
before a complete halt (say when a light goes green before full stop) I
can re-start it by letting up the clutch in 2nd or 3rd / or simply start
it with the starter while rolling.

I see another similar post referring to an "igniter" problem or ignition
switch problem ... but it is not failing randomly, only when I come to a
stop.

No "Check engine" light.

The mechanics at the garage where I changed the oil the other day had no
idea (they did the usual checks and found nothing) and suggested as a
minimum that I run a bottle of injector cleaner through the tank (and
I'm doing that now...). Naturally, when the mechanic went for two
drives in it, it behaved perfectly.

Also they said there is no gas filter, just a strainer at the gas tank.
Is that correct?

Ideas?

Thanks,
Alan


All times are GMT -4. The time now is 12:45 AM.


© 2024 MH Sub I, LLC dba Internet Brands

Page generated in 0.04059 seconds with 6 queries