DelSol B16A Ignition Timing out but Cam Belt Timing is correct
Can anyone help? I'm tearing, what little is left of my hair, out at
the moment. When adjusting my ignition timing by moving the distributor I am unable to line the crankshaft casing mark with the center 16degree timing mark on the pully. The distributor is rotated as far as it wil go towards the firewall. Its still a few degrees off. I have checked the cam belt timing a number of times now looking in case the belt has slipped by a tooth but it looks spot on. I have even tried adjusting cams back one tooth but the car would not start. Currently with the distributor as far towards the firewall as it will go, the car will idle fine but when driving the car has little power. It gets noticeably worse when the car is warm. Is there anything else that could cause the ignition timing to be so far out? Any sensor that could cause the ECU to advance \ retard the timing? Any help is appreciated. Graeme. |
All times are GMT -4. The time now is 01:33 PM. |
© 2024 MH Sub I, LLC dba Internet Brands