TE Chea

Intake manifold has asbestos gasket to insulate heat ( from cylinder
head ), but the 9 nuts which lock manifold onto cylinder head have
no asbestos washer, so heat enters manifold via [i] these 9 nuts [ii]
the exhaust gas channeled to EGR valve [iii] * channeled through
manifold .[iv] manifold chamber via EAC & Fast Idle valves.
http://www.autozone.com/images/cds/g...3d800cf4a6.gif
Designer seemingly assumed ambient air is never >20ēC ( can be
seen from exhaust manifold's front & rear covers
http://www.hondaautomotiveparts.com/...13sm40_d08.gif
- meant to keep exhaust gas hot, unnecessary & bad in warmer
climate ), & users will use * to heat their seats' spaces, so * will
not be >40ēC.
To further cool air intake, I use polystyrene & rubber washers to
insulate chamber from these 2 valves, glued 3 heatsinks onto
chamber, fitted copper wires & hoses ( with water & surfactant )
onto chamber & throttle body. Then air intake is cooler : warm-
starts & hill climbing are easier, in even 27ēC ambient air, let
alone in hotter weather.
These 2 valves' insulations also make Fast Idle valve heat up &
reduce idling rpm sooner, & save petrol during idling / coasting.
I could not post here a photo of my F20A's chamber & valves, looks
like this NG bans any photo.