Help Rear Caliper Rebuild Boot won't fit
I bought some caliper rebuild kit for all four of my brakes. The
front was pretty simple but on the back I am having some difficulty putting on the rubber dust boot on the piston. I first tried to put the rubber boot on the piston then tried to screw on, but the rubber boot wouldn't fit into its place. Now I just put the rubber boot in first then I tried to force the piston through it in a clock ward motion but its not working. Any tips on getting it to go through or should I get a remanufactured one from an auto part store and skip the hassle? |
Re: Help Rear Caliper Rebuild Boot won't fit
Update:
Ok after reading some sites I figured I could cut a plastic cup and shape it like a funnel and slide the piston in as a shoe horn. Now the next question is does anyone know what kind of snap ring pliers I can buy at Sears that will help me take the rear caliper apart? Ones that I need are like this: http://www.performanceforum.com/wesv...akes/bkr12.jpg Thanks |
Re: Help Rear Caliper Rebuild Boot won't fit
googamooga <googamooga@gmail.com> wrote in
news:2da2b312-653d-4a6f-99e6-c2727f26fe1e@l13g2000yqb.googlegroups.com: > Update: > > Ok after reading some sites I figured I could cut a plastic cup and > shape it like a funnel and slide the piston in as a shoe horn. You could also just lube the boot with silicone grease while making sure your hands and the exterior of the boot are dry. In any case, the piston should always be given a light coating of silicone grease before assembly. This will help keep it free for along time. > > Now the next question is does anyone know what kind of snap ring > pliers I can buy at Sears that will help me take the rear caliper > apart? Sears may not cut it. You need to try somebody like NAPA, or one of those Snap-On, MAC, or Matco tool trucks. > > Ones that I need are like this: > http://www.performanceforum.com/wesv...akes/bkr12.jpg > You wanna do just what I wanna do. And I have not yet got around to finding those snap ring pliers deep enough to grab that snap ring properly. Warning: If that snap ring slips off the pliers at any time while withdrawing it from the bore, it will damage the bore, so the stakes are high here! Have you thought about how you're going to hold the cup and spring down while you release the snap ring? There's a lot of spring tension there. Plus you need an air compressor to pop the parking brake piston out of the bore. I bought a caliper from the wreckers for ten bucks so I could experiment, which is how I know all this. That's one complex little beast there. My left rear caliper heats up about 10F hotter than the right (115 versus 105), and I'd like to rebuild both of them before winter. -- Tegger The Unofficial Honda/Acura FAQ www.tegger.com/hondafaq/ |
Re: Help Rear Caliper Rebuild Boot won't fit
Tegger
Man the real funny thing is that the rear calipers were in good shape, I was just going to do a thorough job by doing all 4 but I think I learned my lesson. I think I will just put the dust boot back on and wait til the rear calipers fail, then i will buy a remanufactured one. |
All times are GMT -4. The time now is 08:24 AM. |
© 2024 MH Sub I, LLC dba Internet Brands