Hyundai Trajet Tapping noise when cornering at slow speed
 

Hi,
Anyone shed any light, when I turn a corner at slow speed, the right when
make a tapping noise. I have looked for anything loose under there and
nothing. I have even just replaced the front brakes in case something was
rubbing.

No noise at higher speeds, or in a straight line. Maybe the rocker arms, but
that would knock when the car was rocked hard. his only happens when
cornering.

Any help????

Re: Hyundai Trajet Tapping noise when cornering at slow speed
 

Tapping or clicking on corners only usually suggets CV joints. On older cars
a clean/regrease solves problem. I,m not sure on latter cars.
John

Re: Hyundai Trajet Tapping noise when cornering at slow speed
 

"John" <susan48@aapt.net.au> wrote in message
news:h418ar$56a$1@news-01.bur.connect.com.au...
> Tapping or clicking on corners only usually suggets CV joints. On older
> cars a clean/regrease solves problem. I,m not sure on latter cars.
> John

As you suggested, the right CV joint has split. I will give it a good clean,
re-grease, put the boot back together and tape it up. Hope it will fix it
till I can afford to replace it.


>

Re: Hyundai Trajet Tapping noise when cornering at slow speed
 

"TheDragon" <Respond_To_News_only@gmail.com> wrote in message
news:7cntuoF28jv39U1@mid.individual.net...
>
> "John" <susan48@aapt.net.au> wrote in message
> news:h418ar$56a$1@news-01.bur.connect.com.au...
>> Tapping or clicking on corners only usually suggets CV joints. On older
>> cars a clean/regrease solves problem. I,m not sure on latter cars.
>> John
>
> As you suggested, the right CV joint has split. I will give it a good
> clean, re-grease, put the boot back together and tape it up. Hope it will
> fix it till I can afford to replace it.
>
>
>>

I also noticed one of the wheen nuts was missing. 4 instead of 5. On closer
inspection, the stud has sheared just inside. Where can I get a replacement
M12 stud to replace the sheared one, after its been drilled out by the
garage.

I will then have to buy a new set of wheel nuts as the current ones are not
standard, they have a M12 Hex hole in the end, not the regular M17 head.
>
>

Re: Hyundai Trajet Tapping noise when cornering at slow speed
 

On Jul 20, 4:02 am, "John" <susa...@aapt.net.au> wrote:
> Tapping or clicking on corners only usually suggets CV joints. On older cars
> a clean/regrease solves problem. I,m not sure on latter cars.
> John

Clicking tends to indicate that the joint has been damaged from lack
of grease. Plan on replacing the axle assembly or outer joint.

The stud should be available at any auto parts store.