new guy with a code question
 

Hi. This Hyundai forum seems to have a lot more traffic than the others I visited. I just bought a used 2000 Hyundai Elantra 2.0 sedan with 79,000 miles. The check engine light is on and the codes that came up on the computer are P1624, which is some kind of anti theft system thing, and P0713. The 7013 is: transmission fluid temperature sensor high input. My questions are, what can be done to fix this? Is it a DIY type of thing? Was there a recall or service bulletin on this problem?
Before buying the car, I called a local Hyundai dealer and he said the 100,000 mile warranty is not transferrable to anyone but the original owner, so I guess I'm S.O.L. if I want it fixed for free. Thanks in advance! I think I'll probably become a regular visitor on this site

Peco

--
pecos

-----------------------------------------------------------------------
View this thread: http://www.carstalk.net/viewtopic-436431.htm

Send from http://www.carstalk.ne

Re: new guy with a code question
 

I don't recall any special bulletins about this, but I've seen two basic
problems.

1. The wires to the temp sensor are broken or the temp sensor is
disconnected. The connector is at the very left front of the vehicle. If
you remove the left front splash shield, you'll get a good view of this
little two-pin connector. If the wires are broken, you'll probably need
to replace the terminal in the connector. That'll be difficult to do
unless you have the special tooling required to take apart the connector
and a selection of terminals from which to select the proper one.

2. There's an actual open circuit in the connector itself. In this case,
you'll need to replace the fluid temperature sensor, which is inside the
pan clipped to the valve body. You'll need a pick or similar implement to
remove the retaining clip and pull the sensor end of the connector inside
the transmission. Most diy-ers would be able to do this.

I'd recommend looking at the connector/wiring (and playing with it a
little right at the connector) to make sure it's not broken. If the
wiring and connector are okay and you'd be comfortable doing your own
fluid and filter service on your transmission, go to the dealer, get a
filter and gasket kit, 5 quarts of fluid, and a new sensor. That way,
you'll probably be all repaired *and* have a new filter inside the
transmission.

Also, you may want to register for an account at www.hmaservice.com. It
requires IE, but it's free, and you'll be able to see the shop manuals and
illustrations as well as wiring diagrams and technical service bulletins.

Re: new guy with a code question
 

I don't recall any special bulletins about this, but I've seen two basic
problems.

1. The wires to the temp sensor are broken or the temp sensor is
disconnected. The connector is at the very left front of the vehicle. If
you remove the left front splash shield, you'll get a good view of this
little two-pin connector. If the wires are broken, you'll probably need
to replace the terminal in the connector. That'll be difficult to do
unless you have the special tooling required to take apart the connector
and a selection of terminals from which to select the proper one.

2. There's an actual open circuit in the connector itself. In this case,
you'll need to replace the fluid temperature sensor, which is inside the
pan clipped to the valve body. You'll need a pick or similar implement to
remove the retaining clip and pull the sensor end of the connector inside
the transmission. Most diy-ers would be able to do this.

I'd recommend looking at the connector/wiring (and playing with it a
little right at the connector) to make sure it's not broken. If the
wiring and connector are okay and you'd be comfortable doing your own
fluid and filter service on your transmission, go to the dealer, get a
filter and gasket kit, 5 quarts of fluid, and a new sensor. That way,
you'll probably be all repaired *and* have a new filter inside the
transmission.

Also, you may want to register for an account at www.hmaservice.com. It
requires IE, but it's free, and you'll be able to see the shop manuals and
illustrations as well as wiring diagrams and technical service bulletins.

Re: new guy with a code question
 

I don't recall any special bulletins about this, but I've seen two basic
problems.

1. The wires to the temp sensor are broken or the temp sensor is
disconnected. The connector is at the very left front of the vehicle. If
you remove the left front splash shield, you'll get a good view of this
little two-pin connector. If the wires are broken, you'll probably need
to replace the terminal in the connector. That'll be difficult to do
unless you have the special tooling required to take apart the connector
and a selection of terminals from which to select the proper one.

2. There's an actual open circuit in the connector itself. In this case,
you'll need to replace the fluid temperature sensor, which is inside the
pan clipped to the valve body. You'll need a pick or similar implement to
remove the retaining clip and pull the sensor end of the connector inside
the transmission. Most diy-ers would be able to do this.

I'd recommend looking at the connector/wiring (and playing with it a
little right at the connector) to make sure it's not broken. If the
wiring and connector are okay and you'd be comfortable doing your own
fluid and filter service on your transmission, go to the dealer, get a
filter and gasket kit, 5 quarts of fluid, and a new sensor. That way,
you'll probably be all repaired *and* have a new filter inside the
transmission.

Also, you may want to register for an account at www.hmaservice.com. It
requires IE, but it's free, and you'll be able to see the shop manuals and
illustrations as well as wiring diagrams and technical service bulletins.

Re: new guy with a code question
 

pecos wrote:
> Hi. This Hyundai forum seems to have a lot more traffic than the others I visited. I just bought a used 2000 Hyundai Elantra 2.0 sedan with 79,000 miles. The check engine light is on and the codes that came up on the computer are P1624, which is some kind of anti theft system thing, and P0713. The 7013 is: transmission fluid temperature sensor high input. My questions are, what can be done to fix this? Is it a DIY type of thing? Was there a recall or service bulletin on this problem?
> Before buying the car, I called a local Hyundai dealer and he said the 100,000 mile warranty is not transferrable to anyone but the original owner, so I guess I'm S.O.L. if I want it fixed for free. Thanks in advance! I think I'll probably become a regular visitor on this site.
>
> Pecos


The 00's warranty is transferable.

Its only the (2003?) and higher that aren't transferable.

My 2001's is still transferable - its part of the original warranty
contract which Hyundai can't just change at a whim.

JS

Re: new guy with a code question
 

pecos wrote:
> Hi. This Hyundai forum seems to have a lot more traffic than the others I visited. I just bought a used 2000 Hyundai Elantra 2.0 sedan with 79,000 miles. The check engine light is on and the codes that came up on the computer are P1624, which is some kind of anti theft system thing, and P0713. The 7013 is: transmission fluid temperature sensor high input. My questions are, what can be done to fix this? Is it a DIY type of thing? Was there a recall or service bulletin on this problem?
> Before buying the car, I called a local Hyundai dealer and he said the 100,000 mile warranty is not transferrable to anyone but the original owner, so I guess I'm S.O.L. if I want it fixed for free. Thanks in advance! I think I'll probably become a regular visitor on this site.
>
> Pecos


The 00's warranty is transferable.

Its only the (2003?) and higher that aren't transferable.

My 2001's is still transferable - its part of the original warranty
contract which Hyundai can't just change at a whim.

JS

Re: new guy with a code question
 

pecos wrote:
> Hi. This Hyundai forum seems to have a lot more traffic than the others I visited. I just bought a used 2000 Hyundai Elantra 2.0 sedan with 79,000 miles. The check engine light is on and the codes that came up on the computer are P1624, which is some kind of anti theft system thing, and P0713. The 7013 is: transmission fluid temperature sensor high input. My questions are, what can be done to fix this? Is it a DIY type of thing? Was there a recall or service bulletin on this problem?
> Before buying the car, I called a local Hyundai dealer and he said the 100,000 mile warranty is not transferrable to anyone but the original owner, so I guess I'm S.O.L. if I want it fixed for free. Thanks in advance! I think I'll probably become a regular visitor on this site.
>
> Pecos


The 00's warranty is transferable.

Its only the (2003?) and higher that aren't transferable.

My 2001's is still transferable - its part of the original warranty
contract which Hyundai can't just change at a whim.

JS

Re: new guy with a code question
 

The new vehicle powertrain warranty is for the original owner (2004 and
newer) or immediate family members (1999-2003) only. It won't transfer to
anyone else.

If the previous owner had an extended warranty, that may transfer for a
fee.

Re: new guy with a code question
 

The new vehicle powertrain warranty is for the original owner (2004 and
newer) or immediate family members (1999-2003) only. It won't transfer to
anyone else.

If the previous owner had an extended warranty, that may transfer for a
fee.

Re: new guy with a code question
 

The new vehicle powertrain warranty is for the original owner (2004 and
newer) or immediate family members (1999-2003) only. It won't transfer to
anyone else.

If the previous owner had an extended warranty, that may transfer for a
fee.