Rep Power: 776

I am putting a turbo setup in my b16a3 and i am in need of oversized injectors to do the vafc hack. Can i use dsm injectors? I searched and some said that you needed to bore out the grommet a little bit and but another said you needed to put resistors in the wires to the injectors because they are (hold & peak) style injectors and civic injectors are (saturated).

Does anyone have any info on this?

Also if you know where to buy or if you have dsm or overisized aftermarket ones let me know and ill buy them.

Thanks in advance

John

 
Rep Power: 774

dont really know about about the honda injectors but i do know that DSM injectors are high impedence, and you need a resistor pack that goes with them, but its not too hard to get your hands on those as well, and im sure its not so hard to connect the resistor pack either. good luck

 
Rep Power: 759

yes you need a resistor box from a 92-95 hb OR you can wire 10ohm resisters (inline).

honda-tech has plenty of info and diagrams on this. check it out(use the search function).

and you will also need to bore out the bottom grommet a little bit to make it a nice fit.

i ran dsm's on my honda for a year or so(before i switched ). ran fine.

 
Rep Power: 770

just buy high impedence from accel 250 for 400cc

 
Rep Power: 774

how much do they go for?

dsm injectors are dirt cheap. I'm using them with my set-up

 
Rep Power: 782

Why is that? when 450cc dsm injectors can be had for about $75. If your interested in a set just PM me, I'm sure I have a couple sets laying around somewhere

 
Rep Power: 778

DSM injectors are LOW IMPEDANCE (peak and hold) 92-00 civics use HIGH IMPEDANCE (saturated). You will need a resistor box if using DMS injectors in a 92-00 civic. I don't know why you would use the AFC hack when a crome tuned setup is so cheap.