Nissan 240sx Suspension
 

The 240SX uses a MacPherson Strut front suspension and a 5-link independent rear suspension. The suspension system is supplemented by front and rear sway bars. (The 1995-1998 240SX Standard Coupe had only a front sway bar.) The S14 suspension works in the same way as the S13 although the dimensions of the components are slightly different between the two models.

http://www.240edge.com/basics/suspenfr1.jpg
S13 Front Suspension

http://www.240edge.com/basics/suspenre1.jpg
S13 Rear Suspension

http://www.240edge.com/basics/suspenre2.jpg
S13 Rear Suspension

http://www.240edge.com/basics/suspenfull.jpg
S13 Suspension

A MacPherson Strut suspension consists of an upright (containing the hub) that is supported at the bottom by an A-arm attached to the chassis. The strut is fixed to the top of the upright and attached to the strut tower in the chassis through a pivoting joint. The shock absorber is placed inside the strut, and the spring is positioned around the strut between two spring perches. An additional link is included between the chassis and the bottom of the upright in order to decrease front-to-back movement of the suspension upright. This link is called a Tension/Compression (T/C) rod or just Tension Rod.

The front suspension links include the Lower Control Arm, T/C Rods, and Tie Rods. The links of the rear suspension are the Rear Upper Control Arm, Forward Link, Lateral (Toe) Link, and Rear Lower Control Arm. The rear suspension is housed in a floating sub-frame bolted to the chassis. This sub-frame also holds the differential.

nicepost and info.

ya good info