AutoLab T4/SFWD CRX (pics & vid)
Guest
Posts: n/a
Hello everyone, here are some pics and a vid of our project CRX. Hopefully going to make some events now that we were finally able to afford a real clutch for the car (Exedy twin disk ) The pics show the progress of about 6 months of hard work. The car was a total piece when we got it, we stripped it and completely started over. It was a lot of fun and we're nowhere near to being finished with it.
ERL/Darton sleeved B16
JE/Crower
stock everything else from headgasket up (for now)
stock axles & trans
Skunk2 drag susp kit on KYB
25" M&H
Autronic SMC
PhoenixTurbo.com T3/T04R on 14psi (377whp)
The manifold, downpipe, fmic, charge pipes, and custom cam and crank trigger system were all fabricated in house. Please check out our ad in the new DSport mag.
Vid - 14psi (377whp). Best pass of the night 11.5@128, I'll try to get that vid loaded here in a few.
RIGHT CLICK SAVE AS FOR VIDEO
BIG THANKS:
Sean @ ERL Performance
Ken @ PhoenixTurbo.com
John @ M&H
Bell Motor Service
Steve Nichols
Ben Strader @ EFI101
Tony1 for letting me waste his time on the phone (sorry sir)
Matco Tools
Exedy Clutch
Pics...
ERL/Darton sleeved B16
JE/Crower
stock everything else from headgasket up (for now)
stock axles & trans
Skunk2 drag susp kit on KYB
25" M&H
Autronic SMC
PhoenixTurbo.com T3/T04R on 14psi (377whp)
The manifold, downpipe, fmic, charge pipes, and custom cam and crank trigger system were all fabricated in house. Please check out our ad in the new DSport mag.
Vid - 14psi (377whp). Best pass of the night 11.5@128, I'll try to get that vid loaded here in a few.
RIGHT CLICK SAVE AS FOR VIDEO
BIG THANKS:
Sean @ ERL Performance
Ken @ PhoenixTurbo.com
John @ M&H
Bell Motor Service
Steve Nichols
Ben Strader @ EFI101
Tony1 for letting me waste his time on the phone (sorry sir)
Matco Tools
Exedy Clutch
Pics...
Thread
Thread Starter
Forum
Replies
Last Post
2TONE_93GT
Automotive Pictures & videos
9
Sep 1, 2006 06:48 PM
Eugene Galchenko
Honda Mailing List
0
Jan 6, 2004 12:19 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)




:thumbsup
