RF amp for sale
#1
~~ Hardcore Newb ~~
Thread Starter
Join Date: Jul 2006
Location: Scarborough,Ontario
Posts: 73
Rep Power: 652
RF amp for sale
I have for One (1) Rockford Fosgate 851S
Contains Everything in the picture
215 watts RMS x 2 at 4 ohms
425 watts RMS x 2 at 2 ohms
850 watts RMS x 1 at 4 ohms in bridged mode
stereo or bridged mono output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way Crossover required)
requires 4-gauge power and ground leads and a 60-amp fuse — wiring and hardware not included with amplifier
variable 50-250 Hz high-pass/low-pass crossover, 24 dB/ octave
TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise
NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance
TRANS•ana circuit designs keep voltages low and signal paths simple in the pre-amp section, for minimum distortion and maximum musicality
MEHSA provides more efficient transfer of heat from MOSFET output devices to the heatsink for cooler operation
preamp outputs for convenient daisy-chaining of amplifiers
Punch Bass (0-18 dB at 45 Hz) with wired remote control
Reason for selling: Jeep needs Rapair
250 OBO
Contains Everything in the picture
215 watts RMS x 2 at 4 ohms
425 watts RMS x 2 at 2 ohms
850 watts RMS x 1 at 4 ohms in bridged mode
stereo or bridged mono output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way Crossover required)
requires 4-gauge power and ground leads and a 60-amp fuse — wiring and hardware not included with amplifier
variable 50-250 Hz high-pass/low-pass crossover, 24 dB/ octave
TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise
NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance
TRANS•ana circuit designs keep voltages low and signal paths simple in the pre-amp section, for minimum distortion and maximum musicality
MEHSA provides more efficient transfer of heat from MOSFET output devices to the heatsink for cooler operation
preamp outputs for convenient daisy-chaining of amplifiers
Punch Bass (0-18 dB at 45 Hz) with wired remote control
Reason for selling: Jeep needs Rapair
250 OBO
Last edited by Jboy2; 09-24-2006 at 10:25 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
mugen_d17a1
Car Parts For Sale
1
12-13-2008 03:59 PM
techie
Miscellaneous Stuff For Sale
1
10-21-2008 03:54 PM
Eugene Galchenko
Honda Mailing List
0
01-06-2004 12:19 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)