A-Pillar Rust Repair
03-26-2009, 11:04 AM
#1
~~ Hardcore Newb ~~
Thread Starter
Join Date: Jan 2007
Location: Oakville, Ontario
Posts: 23
Rep Power: 632 
A-Pillar Rust Repair
Hey guys,
I drive a 1995 ford probe gt, and the d/s a-pillar has rust bubbles. The section is only about 3 inches long and an inch wide, but as we all know with rust, the backside is probably tripple the size.
Anyways, I know how to go about doing it, cut it all out, clean it up, weld in a new piece or fiberglass it in (if small enough).
But my question is, does any one know of a cheap place to get this done? Also, how much do you think I will end up spending, if they have to cut out the old crap, weld in new? I want no painting done as I am doing that myself
Thanks a lot!
I drive a 1995 ford probe gt, and the d/s a-pillar has rust bubbles. The section is only about 3 inches long and an inch wide, but as we all know with rust, the backside is probably tripple the size.
Anyways, I know how to go about doing it, cut it all out, clean it up, weld in a new piece or fiberglass it in (if small enough).
But my question is, does any one know of a cheap place to get this done? Also, how much do you think I will end up spending, if they have to cut out the old crap, weld in new? I want no painting done as I am doing that myself
Thanks a lot!
Thread
Thread Starter
Forum
Replies
Last Post
springs@mail.gr
Honda Mailing List
1
01-11-2012 11:08 AM
springsingreece@gmail.com
Hyundai Mailing List
0
05-02-2007 09:36 PM
springs@mail.gr
Honda Mailing List
0
05-02-2007 09:33 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)