Dcalado_

anyone know where to pick up mods for my 2.8? iv been seaching the net and most of the sites i find are for the 3.4... so if u got a good site post it, its much appreciated

97z2801ss

engine swap?

Dcalado_

lol iv heard that many times... iv considerd it also.. but right now that would cost to much considering, aprox 2000 for the engine... 1700 for the trany... and even after that the rear axel might not be able to handle the power.. so im just looking into some performance mods for this.. and i plan to purchase another camaro in the future

RFF

****, their are 4 bangers running around that have as much displacement as you. I would just save up for an engine swap. If you know what you are doing you could get the whole thing done for around $1200.

archemedes

check some mods for the front drivers it's the same engine

Dcalado_

front drivers as in?

Soon2B8

yeh a 3.4 is also pretty helpless also unless big money is invested. Do the swap!

NCamaro94

if you want to do a v6 swap then swap up to the 3800 aka 3.8L

archemedes

pre '91 sunbird, cutlass, a few others like that

Camarocam

There is a guy at autozone who has a camaro with big hood scoop and guages in it. my and my friend were checking it out and you can see the back of the motor though the scoop and ot was a 2.8 we go inside and ask our friends that work there whos it is? he says its the managers and it would kick my camaros @$$ so I ask him what is done to it he wouldnt say and my friends said it has NOS but I dont know he said he will race me for 1000 dollar right now I dont have a 1000 dollars but I would race him just for the fun he didnt want to so I Dont knw if it was fast or not but my friends that work there say it halls @$$.

Dcalado_

interesting... im still looking around for mods.. but cant seem to find the right ones, i bought some headmen headers a while back and got them jet hot coated and went to install them and they wouldnt fit.. not enough room on the sides.. so im thinking i have to pull the engine just to get them on... and that still leaves me with another problem.. the EGR lol i would have to tap a hole in the headers and do some custom work because if i dont.. it would never pass aircare.. and its just a big hassle. But im still looking... :thumbsup:

Camarocam

My headman's had to go in from the bottom of the car even though it looked easier to get them in from the top!

Mike Jones

iTrader: (1)

Heads and a cam would do wonder's for that engine.

Dcalado_

hmm i cant really remember if i even tryed from the bottom :banghead: either way its going to be hard... and last week i had to replace the exhaust manifold gasket... major leak in it.. and i found one of the bolts is broken in the head.. flush against it i tryed to center punch it.. and i had this easy-out type thing from canadian tire it didnt work.. and i didnt wanna pull the head off to get the broken bolt.. so i slapped it back together with the broken bolt still in there

Mike Jones

iTrader: (1)

Perfect, now you have to take the heads off so get them done while they're off.