VRE-Project Supercharged '94 Trans Am
3 Attachment(s)
This project consisted of transforming this 1994 Trans Am daily driver into a winner at the strip. It came to us with blown engine from the Powerdyne it previously had. We built a fully forged 355ci engine to accomidate the 20# of boost, from the new Vortech supercharger the customer(cjmatt) would like to run. The short block consisted of a Callies Dragonslayer crankshaft, Compstar connecting rods, and Diamond Pistons. We finished it off with a LT1 mainfold, unported LT1 cylinder heads, ATI damper and CSI electric water pump.
We dynoed this past Saturday and were very pleased with the results 518/467 at only 10psi. Plans are to upgrade the fuel pump from a single 255lph to the dual in-tank setup, and then put on the smaller pulley. Attachment 157916 http://victoryracingengines.com/albu...0518.sized.jpg http://victoryracingengines.com/albu...0523.sized.jpg http://victoryracingengines.com/albu...0520.sized.jpg http://i29.photobucket.com/albums/c2.../cjmatt012.jpg Attachment 157917 Attachment 157918 http://victoryracingengines.com/albu...0650.sized.jpg .http://victoryracingengines.com/albu...Dyno.sized.jpg |
me want how much thatcost?
|
Pm Sent
|
god thats bitchin. Me next ;)
|
Sounds good to me.:)
Originally Posted by paarman97maro
...Me next ;)
|
thats sweet!
|
thanks for the pm!!!
if and when i have motor done it will be sent to u guys!! thanks for the sweet examples |
I like the burgundy paint on the bird. You don't see that color very often anymore on the LT1 :) Motor looks and runs great, obviously based on the dyno sheet !!! Congratz ! :D
|
Sweet engine! God i wish i was rich.
|
giggity...lol.
damn i would love to work for you guys. i love building motors. |
nice :D
|
simply bad ***
|
1 Attachment(s)
Thanks everyone for taking the time to look over the project and for all the positive feedback.
Attachment 157667 |
How much would that motor cost installed? I have a 94 Z28 with a LT4 hot cam package and some other goodies. Would there be anything I would need to change in my motor for that to fit it?
|
That engine was roughly $5000.00 which included Callies Dragonslayer 3.480" stroke crankshaft, Compstar 6.000" connecting rods, Custom Diamond Pistons, Total Seal AP Series rings, Callies Splayed Main Caps, and ARP Main Studs. Installation is $1000.00, and dyno/tuning is $500.00.
|
All times are GMT -4. The time now is 11:44 PM. |
© 2024 MH Sub I, LLC dba Internet Brands