Is this bad?????
05-07-2005, 10:45 PM
#1
~~ Hardcore Newb ~~
Thread Starter
Join Date: Feb 2005
Location: Hamilton, Ontario
Posts: 33
Rep Power: 702 
Is this bad?????
I dunno about you guys but this doesnt look to good to me!!!
We think the bearing end cap came off and ****ed **** up, as you can see it in the picture....also that rod is ****ED, hard to tell though :P
P.S. more of the block would come off if i took a motor mount off hahahaha
We think the bearing end cap came off and ****ed **** up, as you can see it in the picture....also that rod is ****ED, hard to tell though :P
P.S. more of the block would come off if i took a motor mount off hahahaha
05-08-2005, 10:07 AM
#5
~~ Hardcore Newb ~~
Thread Starter
Join Date: Feb 2005
Location: Hamilton, Ontario
Posts: 33
Rep Power: 702
ahah yea so far bondo looks like my best bet! :P
Its actually the engine outta my Isuzu pickup. I was driving down 403 doing about 100kmh coasting in 5th gear and then BAM. I was pretty pissed it was about 3am and I was tired
Heres the truck:
Its actually the engine outta my Isuzu pickup. I was driving down 403 doing about 100kmh coasting in 5th gear and then BAM. I was pretty pissed it was about 3am and I was tired
Heres the truck:
eeeyikes
05-08-2005, 03:56 PM
#9
Experienced GTcars Poster
Join Date: Feb 2005
Location: cruizin on a street near you
Posts: 2,087
Rep Power: 744
Originally Posted by jdmgsr
its a filler used by bodyshops
actully i know a few ricers that are sposered by bondo they give them discounts on it at canadian tire ...its soo solid
05-08-2005, 04:30 PM
#11
Junior GTcars Poster
Join Date: Feb 2005
Location: Hamilton, ONT
Posts: 219
Rep Power: 707
Strong isuzu bottom ends i guess...140,000 km and its gives out!, didnt something similar happen to the original engine??...haha you got some bad luck there timmy!
p.s. get the god damn truck done and on the road!
-Mike
p.s. get the god damn truck done and on the road!
-Mike
Thread
Thread Starter
Forum
Replies
Last Post
honda video
Honda Videos
0
04-17-2008 07:09 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)