I envy you LS1 guys...
 

Becuase the LT1 engine compartment is a piece of s#it! Been working on my engine bay clean up for the past couple weeks now and today didnt go quite as well as i'd hoped. Brief overview. Broke exaust manifod bolt. Altenator is trash, broke 2 new spark pulgs, an O2 sensor, temp sensor on the exaust manifold, and the oil filter wont come off (thats not GMs fault, thats the lube shop putting it on too tight). But... got one manifold off. woooo :( Im done for today. I can't aford to brake something else. Gm couldnt make the damn car 2" wider and longer could they?

haha. welcome to the nightmare that LT1 guys love to hate.lol. so what kinda headers you decide to go with? it is a huge PITA job and it kinda sucks but when its done you feel like a new man and the difference is pretty nice. good luck!!!

i dont see how an LS1 install is much easier. ive still heard horror stories from noobs like you two installing LS1 headers.

ive never heard a bad thing abuot LS1 header installs. all in all my header job was very smooth except for pulling the trans out after dropping a nut in the starter hole. other than that it was textbook.

It will all be worth it in the end Grant. You know better than most of us that patience pays off. Just keep thinking about how happy it will make you in the end...kind of like your paint job!

what the ****? if you dropped a bolt into your starter hole just take the dust shield off the front of the bell housing.

As a whole there isn't a big difference but to install header's it's quite a bit easier on LS1's.

there not as old...

Any engine period is a PITA to work on in an F-Body....just look how far back the engine sits. People with GTOs and Vettes LOVE the room they have to work on there cars.

That's huge, my '94 lived in the salty roads of Chicago before I bought it so it fought me every step of the way whenever I did any mods due to the rust. Bolts would always break and such. On my LS1 that's just not the case, but just to be safe whenever I do mods I change all the bolts and nuts over to stainless steal ones just so I won't have any problems in the future.

i installed headers on an ls2 and it was cake and a half.

I've heard quite the opposite, actually. I've heard of total noobs, myself included that have done a header install with no previous autmotive experience, and just a guide online to go off of.

Course there's gonna be a couple bad apples in every bunch, I suppose.


But back to the issue at hand...Even for us LS1er's there aint much room at all.

i dont think you know who you are talking to.haha. i wouldnt of pulled the trans for nothing. it wasnt anywhere near the flywheel that i could see and i had a magnet all over that ******. i figured it must have fallen past the clutch assembly and more towards the front of the trans, so i pulled it apart.lol. only took about an hour out of my install time.

well i was reading some guys website who said it took him 7 hours to install...i think they were SLP LTs. thats just way too long. so i assumed it must be the same for all f bodies.

7 hours? install headers on your car caleb, see how long it takes you.lol