tentoesdown

First of all hello,My problem is that my Honda's transmission went out awhile back, so I have to replace it. Now I can shell out 800+ to get it fixed, but I'd much rather learn to do it myself. Now I'm not too experienced when it comes to mechanics, the most I've ever did was change the brakes on my own; but I figure it's a good time to start to learn. I have basically zero idea where to start. So I was hoping someone could point me in the direction of an "how to" manual on removal/replacement of an transmission. Tools won't be an issue, I'm pretty smart when it comes to learning this type of stuff so I'm not too worried. Think of this as my personal Frankenstein! If you can point me to some good websites or guides on how to do it would be awesome. Specs: Honda Accord - 2.2L - 4CL - 92'Here's a picture.http://img382.imageshack.us/my.php?i...d1.jpgI'll be going to a junkyard soon to get a transmission with something like a 30 day warranty. Thanks --MarkAutomatic

imported_hsueh010

First off if you're tackling a job like this for the first time it's best to get a good manual. I don't believe the full information can be easily found on line.However you can search these pages, which typically have most of the information here:http://www.autozone.com/az/cds/en_us...oPages.htmSome guide line steps to swapping a transmission.1. Make sure you disconnect the battery before starting.2. Remove the starter motor.3. Disconnect all electrical components that are connected to the transmission.4. Jack up the front of car and be sure it is properly supported.5. Remove the CV shafts. (Or at least separate them from the transmission)6. Remove the inspection plate.7. Remove bolts connecting the flex plate to the torque converter.8. Place a jack under the transmission with a block of wood between the two so you don't damage the trans.9. Remove bolts connecting tranmission to the engine.10. Separate the trans and engine.

panaphobic_17

well, good thing is that it's a honda, so anything with the same series engine (d-series, b-series, h-series, etc....) can pretty much use the same transmission. as for how to do it yourself, the best thing would be to go and buy a haynes repair manual. those are great since they actually took the car that the book is for, and completely tore it apart and put it back together. now, doing a transmission swap take a lot of time. if it says it'll take 6-8 hours to do, you'll probably need to double it if you've never done it yourself. you'll need a lot of specialty tools too. and probably someone willing to help. transmissions aren't light! automatic transmissions are more complex, thus they weigh more than manual transmissions. you'll also need jack stands, but preferrably, you should use a lift. you'll have a lot more room and make it'll you're life much easier.hope this helps!