DOHC ZC Problems
#1
DOHC ZC Problems
Hey Guys Thanks For Helping Out,
I just finish dropping a ZC DOHC in my EF Si.
i have come to a stop and am need of guidance.
i have looked at all possible problems to solve this error.
The car Cranks but wont turn over.
i have fuel, air, and a spark.
when the car is cranked i hear some backfire soo i think...
I've check my Firing order and is good 1-4-3-2 (new spark plugs)
i've change timing belt and did a timing adjustment to perfection. lined the block to the craNk and the pulleys in the center.(as explained on this site)
i am frustrated but i understand this is all part of swaps :sly
i am lost and dont know what else to do
I just finish dropping a ZC DOHC in my EF Si.
i have come to a stop and am need of guidance.
i have looked at all possible problems to solve this error.
The car Cranks but wont turn over.
i have fuel, air, and a spark.
when the car is cranked i hear some backfire soo i think...
I've check my Firing order and is good 1-4-3-2 (new spark plugs)
i've change timing belt and did a timing adjustment to perfection. lined the block to the craNk and the pulleys in the center.(as explained on this site)
i am frustrated but i understand this is all part of swaps :sly
i am lost and dont know what else to do
#5
Originally Posted by tmccall32
check your order on the distributer, if you are 1 plug out it will crank and sputter and backfire.....make sure you are 1432 from d ( i think bottom left corner of the distributer)
The problem with this car has been fixed. it turned out to be multiple things, it didn't fire because no cam sensor was wired. Their was also no coolant temp sensor wired..
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)