Red Liner

Will it fit??

i know nothing about Honda's so i'm wondering....i know the B series will fit under the hood...

anywho....lemme know...

thx in advance

Midnight Racer

iTrader: (2)

recently hasport has reintroduced the mounts to drop in a H22 into an ef but there not cheap http://www.hasport.com/

ModSpec

I remember three or four years ago someone had a 90 Civic running H22 at Cayuga... They didn't have mounts so they welded the old mounts directly on the frame...

It was fun to see the guys shaking when they were getting out of the car after their run...

BrowNKiD

iTrader: (1)

other than clearence issues ef are cable clutches while h22s are hydrolic...

Honda Tech

oh thats the !!! ya civtegra90's civic rattles and vibs like a bitch too, its just from the stiff mount, but direct welded would be absolutly crazy!!

but yes it would fit, but it would take a lot of body mods and you would have to hook up hydrolic clutch and rewire the whole damn car. ( well u dont have to but it would be easier to rewire completely )

and enjo has mounts too

4thgen

You can get an h2b kit (adapter plate) to use a b series tranny. I think (someone correct me if i'm wrong) you can then use the b-series mounts.

fastestcivic

iTrader: (4)

the b series plate is not in canada yet and will not .. only tranny mount is b series the others are hasport or custom....also gearing for different issues sucks...long story theres huge write ups.....
hasport did make mounts but havent seen anyone use them and heard clearance is still issue and no shop will install that engine in a ef civic unless its hack or track-car...
all in all its to much money for poor quality ride...
red_liner u no i have lots of knowledge when it comes to 2.2 and hondas
by the way...wat happened to the project rust tang hahahah hit me on msn...

phillet

Make shure your car is in good shape other wise it will fall apart fom the shake. And be pre pared for lots of interior peices to raddal like crazy have fun.