BMWTN

I知 new to the Honda forum and did a little searching with no luck so here it goes .I知 working on a 1995 Honda accord 4 door V6.Im trying to replace the rear struts the lower bolt holding the strut is a problem. It was hard to get loose but I freed it with a impact wrench but apparently there is a rubber bushing mess keeping the bolt from coming out to free the strut. What痴 the procedure in removing and replacing it? Thanks in advance.DIY?

boostfed

hey,
I've gone through that same process before, if you can't absolutely remove that bolt out that holds the strut to the lower control arm, A) cut the ends of the bolt off and use a something to pound out the remainder metal material left in the bushing or B) take it to a shop and have them do it or C)heat the bitch up to a very high degree and try to loosen it..
i hope it helps...