Help!!!!! Timing Belt
#1
Help!!!!! Timing Belt
Hi there i need to replace my timing belt i worked for 4 hours today at the stupid bolt on the crankshaft drivebelt pulley bolt and gave up but i noticed something that kind of bugged me and that is that the crankshaft drivebelt pulley will spin pretty easily with just my hand so my questions are is it supposed to spin so easily and what is the best way to get this bolt off im driving a 1986 CRX dx
#3
#5
Hi there i need to replace my timing belt i worked for 4 hours today at the stupid bolt on the crankshaft drivebelt pulley bolt and gave up but i noticed something that kind of bugged me and that is that the crankshaft drivebelt pulley will spin pretty easily with just my hand so my questions are is it supposed to spin so easily and what is the best way to get this bolt off im driving a 1986 CRX dx
Depending on your pulley type, it may be possible to make up a locking bar tool. Get yourself a 15inch lenth of 1/4 inch bar or angel iron and drill two holes in it that are same space apart as those in pulley. Fit 1/4 inch bolts with locknuts through holes, which are long enough to fit into pulley holes and you have your tool.
You lock the bar onto garage floor or block of some kind and loosen pulley bolt with breaker bar.
If however your pulley has the hexagonal recess on flange, you could modify a large nut and make up a different tool, or give in and buy correct tool from Honda dealer.
If you intend keeping vehicle for a while then an investment anyway.
Thread
Thread Starter
Forum
Replies
Last Post
fish
Honda Mailing List
36
08-12-2006 11:34 AM
fish
Honda Mailing List
0
08-09-2006 11:59 AM
fish
Honda Mailing List
0
08-09-2006 11:59 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)