Replacing the muffler without tools was harder than
I thought it would be.

I got the old muffler off. How do I get the
gasket off? Is it hard to do?

This is the one part I dare not screw up since
the exhaust pipe has to stay.

 

A. Smith wrote:
> Replacing the muffler without tools was harder than
> I thought it would be.

no kidding! i'm impressed. do you have it on video?

>
> I got the old muffler off. How do I get the
> gasket off? Is it hard to do?

no. it just pulls out. you clean out the debris, put the new one in,
and you're in business. in the immortal words of the haynes manual,
"assembly is the reverse of removal".

>
> This is the one part I dare not screw up since
> the exhaust pipe has to stay.

 

"A. Smith" wrote:
>
> Replacing the muffler without tools was harder than
> I thought it would be.

Then what did you use exactly?

> I got the old muffler off. How do I get the
> gasket off? Is it hard to do?

Exhaust gaskets on Hondas are usually the ring type. These tend to get
crushed into a groove on the end of what's officially known as the B pipe
(the middle exhaust pipe). Sometimes you can pop these out with a small
screw driver. However, sometimes you need a small sharp cold chisel to get
under it though be extremely careful not to damage the B pipe. Hint, the
ring gaskets are pretty soft while the steel of the B pipe flange isn't so
if you're hammering away at it then your probably attacking the wrong thing
(a few light taps should be all that's necessary to get under it and then
pop it out with a screw driver).

Eric

 

Eric wrote:
> "A. Smith" wrote:
>
>>Replacing the muffler without tools was harder than
>>I thought it would be.
>
>
> Then what did you use exactly?

OK, usually and appropriate tools.

>
>
>>I got the old muffler off. How do I get the
>>gasket off? Is it hard to do?
>
>
> Exhaust gaskets on Hondas are usually the ring type. These tend to get
> crushed into a groove on the end of what's officially known as the B pipe
> (the middle exhaust pipe). Sometimes you can pop these out with a small
> screw driver. However, sometimes you need a small sharp cold chisel to get
> under it though be extremely careful not to damage the B pipe.

I was going to try a channel lock, but the gasket is in a groove?

Hint, the
> ring gaskets are pretty soft while the steel of the B pipe flange isn't so
> if you're hammering away at it then your probably attacking the wrong thing
> (a few light taps should be all that's necessary to get under it and then
> pop it out with a screw driver).
>
> Eric

My tool of last resort is a Dremmel with a cut-off wheel. I thought I
would "carefully" cut the gasket in two.