Klaus Macon

Looking for manual info on changing serpentine belt. All help is
appreciated. Thanks, DoItYourselfer

hyundaitech

Following are instructions for the 2.7. I'm presuming you have the V6
since the four has two belts.

You'll either need a 3/8 drive ratchet or a 17mm open end wrench,
depending on your tensionser type. Release the tension using the
appropriate tool and slide the belt off one of the pulleys. You'll need
to remove the two 12mm bolts holding the tensioner in place and remove the
tensioner. Remove the belt and put the new one in place, reinstall the
tensioner, and then, using the same tool as above, move the tensioner and
install the belt.

Klaus Macon

"hyundaitech" <notpublic@not.public.com> wrote in
news:054d3ec2af801eb5b82e93b086c44821@localhost.ta lkaboutautos.com:

Thanks H-tech,
Sorry, my fault for not being specific. It is a 4 cyl and there are 2
belts. In any case, I appreciate it. diyer

hyundaitech

Loosen the 14mm nut on the back of the pulley for the a/c-p/s belt
tensionser. Then loosen the tensioner positioning bolt and remove the
belt.

Loosen the 12mm bolt holding the top of the alternator to the bracket.
Then loosen the 12mm tensioning bolt. Remove the belt.

Install in reverse.