2000 Sonata stoping problem
06-02-2005, 03:26 PM
#1
Guest
Posts: n/a
2000 Sonata stoping problem
Hello!
I have a question about my 2000 6 cyl Sonata. At the light the car
stopped (the AC was on) and the check engine light came on. I managed
to start the car (CEL did not come on), drove into the parking lot and
tried to recreate the problem but could not. I hooked up the ODBII
reader and got the following codes:
0335 - crankshaft position sensor A circuit
1372 - ?
What does this all mean? Car stoppage at the light is happenning for a
while now.
Your response is greatly appreciated
I have a question about my 2000 6 cyl Sonata. At the light the car
stopped (the AC was on) and the check engine light came on. I managed
to start the car (CEL did not come on), drove into the parking lot and
tried to recreate the problem but could not. I hooked up the ODBII
reader and got the following codes:
0335 - crankshaft position sensor A circuit
1372 - ?
What does this all mean? Car stoppage at the light is happenning for a
while now.
Your response is greatly appreciated
06-02-2005, 06:18 PM
#2
Guest
Posts: n/a
Re: 2000 Sonata stoping problem
Both of these are codes for the crank sensor. I've not seen these codes on
this engine caused by anything other than the sensor itself. Replace the
sensor and all should be well. It bolts into the block behind the
starter. For the DIYer, it's probably easiest to remove the starter and
then unbolt the sensor and pull it out.
this engine caused by anything other than the sensor itself. Replace the
sensor and all should be well. It bolts into the block behind the
starter. For the DIYer, it's probably easiest to remove the starter and
then unbolt the sensor and pull it out.
06-02-2005, 06:33 PM
#3
Guest
Posts: n/a
Re: 2000 Sonata stoping problem
Thanks, I hoped you would answer, you are the man!
What is interesting that when I read the codes, the the check engine
light was not on!
How is it possible that those codes were raised without the lights on?
Also how does this
sensor relate to the engine stopping?
What is interesting that when I read the codes, the the check engine
light was not on!
How is it possible that those codes were raised without the lights on?
Also how does this
sensor relate to the engine stopping?
06-02-2005, 07:41 PM
#4
Guest
Posts: n/a
Re: 2000 Sonata stoping problem
Most failures on OBD-II compliant vehicles won't set the "Check Engine"
lamp until they happen once each in two consecutive drive cycles.
This sensor relates the crankshaft position and speed to your ECM.
Without this information, it doesn't know which plug/injector to fire or
when. As far as your ECM knows, when there's no readout from the sensor,
the engine is not turning.
lamp until they happen once each in two consecutive drive cycles.
This sensor relates the crankshaft position and speed to your ECM.
Without this information, it doesn't know which plug/injector to fire or
when. As far as your ECM knows, when there's no readout from the sensor,
the engine is not turning.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)