I have two '02 Hyundai's, a 4 cyl Sonata, and an Elantra. both have approx
50k miles. I have taken good care of these cars, however as with most
cars, the check engine light comes on occasionally. I'm a DIY, I would
like to ask if anyone would recommend which software or scanner to use
with these cars that works well and of course not to costly. I would
prefer using my laptop if all I need to buy is software and a serial
interface cable.

 

geek_pete wrote:
> I have two '02 Hyundai's, a 4 cyl Sonata, and an Elantra. both have approx
> 50k miles. I have taken good care of these cars, however as with most
> cars, the check engine light comes on occasionally. I'm a DIY, I would
> like to ask if anyone would recommend which software or scanner to use
> with these cars that works well and of course not to costly. I would
> prefer using my laptop if all I need to buy is software and a serial
> interface cable.
>
You can get the codes scanned free at Autozone or Pep Boys. You'll need
to look up the results on Hyundai's Webtech website.

If you want to buy a scanner, it will cost a minimum of $100 for one
that only scans and substantially more for one that resets the ECU.

 

thank you for replying to my question. I would like to ask if you use one
and if you do, would you recommend it ? The one that resets the ECU cache
of error codes would be desirable if not too much more costly.

 

"geek_pete" <razz21346@yahoo.com> wrote in message
news:690d6c53dceee8322430d00be8f02e86@localhost.ta lkaboutautos.com...
> thank you for replying to my question. I would like to ask if you use one
> and if you do, would you recommend it ? The one that resets the ECU cache
> of error codes would be desirable if not too much more costly.

I've been using an Actron CP9135 code scanner, which can be had for
about $125 or less if you shop around or check out eBay. It reads codes,
clears them, and can check the status of the I/M monitors. Requires no
special skills to use. You just plug it in and hit the read button to read
the stored codes, then hit the clear button to erase them. No batteries
required.

There's also a cheaper CP9125 for under $75, which only reads & clears
codes, and a more expensive CP9145 for over $200, which also lets
you record & playback real-time data & freeze-frame data.

Bob

 

I recently purchased a Actron CP9125 for $75 from Northerntool and it works
fine plus it will erase the codes for you.