Rep Power: 805

I used blue 5 led lights.. and I have 13 extra now lol.

 
Rep Power: 935

Nice, Did you consider changing the needles to blue?

 
Rep Power: 822

looks awesome was it really hard to do?

 
Rep Power: 730

damn i want that ..but doesnt really go with the red seats

 
Rep Power: 805

I didn't consider changing the needles to blue. I wouldn't want to deal with putting the needles out and back in their proper location lol. This is about the fourth time I have taken my dash apart. It's not too hard to do it takes me a few hours cuz when I put it back together I make sure everything is very tight. I intended to repaint my air vents gray as well but I could not get the air vent by the air bag out.

 
Rep Power: 805

Also I used 1/2" instrument panel sockets. No soddering here I didn't realize that there was a need to sodder until I researched it a little further after buying the lights. I got them on ebay and it had said they were nonpolarized so I was just going to replace all my lights with them (turned out to only use 7 once I realized I need to buy 7 bases and that they were in fact polarized). It is just something I had always thought about doing and ended up spur of the moment deciding to actually go ahead and do.

 
Rep Power: 1126

looks good, wish it worked on my gp (my gauges light up orange even with blue lights behind)

 
Rep Power: 759

Are you talking about the vents by the passenger side airbag? They're not hard to take out at all. Just a couple of 7mm hex head screws.

 
Rep Power: 716

that looks awsome if its not to hard i might try to do it someday

 
Rep Power: 861

nice!

 
Rep Power: 805

idk the screw was gone the vent just would not budge.. seemed like it would break if pulled on any harder

 
Rep Power: 1126

has it been painted before?

 
Rep Power: 785

I think it looks great with red needles

 
Rep Power: 1126

I agree it's a good contrast, and makes it quickly readable at speed

 
Rep Power: 805

Thanks Yes, the air vent was painted before (not by me). Might just use a foam brush on it? I popped the air vent on the opposite side out with no problem.