VID: 4G63T Breaking point
01-21-2006, 03:09 PM
#1
~~ Hardcore Newb ~~
Thread Starter
Join Date: Dec 2005
Posts: 60
Rep Power: 674 
VID: 4G63T Breaking point
This is a 4G63T stock longblock but has all sorts of bolt ons but internally stock. The owner has a fully built long block ready to go did this vid just for ***** sake.......Enjoy
DYNO http://1320video.com/vids/12.28RedRumDyno.wmv
TRACK http://1320video.com/vids/scribner10.7.wmv
DYNO http://1320video.com/vids/12.28RedRumDyno.wmv
TRACK http://1320video.com/vids/scribner10.7.wmv
01-25-2006, 12:09 PM
#3
Average GTcars Poster
Join Date: Feb 2005
Location: GTA
Posts: 472
Rep Power: 712
Well to be honest with you, that guy was an idiot. He was told long before that NOT to try to make that much power out of a stock 7-bolt motor, well actually any 7-bolt motor. It was bound to happen when boosting 30+psi on a stock bottom end. You see when it comes to the 4G63T, the 6-bolt crank is the only way to go. Believe me, this was not intentional.....did u see the look on his face...priceless.
01-25-2006, 04:23 PM
#4
~~ Hardcore Newb ~~
Thread Starter
Join Date: Dec 2005
Posts: 60
Rep Power: 674
There is no way even a 6 bolt can stand 35 + PSI with stock internals there are few stock motors that can . They new the motor was gonna blow they wanted to see how much power it could make before it did.
And they found out 455 whp
And they found out 455 whp
01-25-2006, 10:57 PM
#7
Average GTcars Poster
Join Date: Feb 2005
Location: GTA
Posts: 472
Rep Power: 712
Originally Posted by TORONTOTALON
There is no way even a 6 bolt can stand 35 + PSI with stock internals
John Shepherd makes about 1200hp with a stock 6-bolt crank
, as mentioned with 2 less pistons :thumbsup:
Last edited by DSMonster; 01-25-2006 at 11:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)