Rep Power: 804

I got a gauge pod for the roof piller and a air fuel and voltmeter gauge ( that will be replaced with a trans temp later) the voltmeter I have no problem hooking up but the air fuel has got me I have a carb and no computer it says to hook it up between the computer and sensor I dont have a O2 sensor either I know I will have to get one of those but wil it work with out a computer?? and if so where should i hook it up at stright to the sensor or what?

 
Rep Power: 967

well i dont know what kind of gauge you got, but you should be able to buy a sender just for that specific gauge and hook it right up.

 
Rep Power: 1125

you need an o2 sensor placement is also critical since too far back and it won't get hot enough to read acurate too close same idea

 
Rep Power: 804

yeah i talked with my friend and he said to get a o2 sensor and the directions said to put it in right around the collecter so that is what i will do. thank for the help

 
Rep Power: 0

I wouldn't buy an air/fuel guage without a wideband 02

 
Rep Power: 804

well I got the guage from a friend for 40$ with pod and voltmeter so I though that was a pretty good deal. I know I dont need a voltmeter but it came with it so I have it until I replace it with a trans temp