Rep Power: 875

Edelbrock headers! got them on an awesome trade for my kicker 10" that no one wanted. I painted them flat black and am trying to get my old manifolds off today. Ill get a sound clip up as soon as i get them installed!

 
Rep Power: 1093

looks nice, but that paints gonna melt in 5 mins... Unless you got hi-temp paint.

 
Rep Power: 875

hi got hi heat header paint with ceramic... its been tested up to 1200 degrees. I dont think they will get that hot

 
Rep Power: 794

looks good cant wait to hear the clip

 
Rep Power: 763

thats freaking awesome

 
Rep Power: 763

that tangerine is sick but i dont think it would look to good on a 3rd gen....i dunno why just doesnt

 
Rep Power: 875

I dont know why you put that in this thread.lmao. but i decided to paint it black anyway. I wanted a car that wasn't gonna stick out a lot b/c im not the slowest driver on the road.

 
Rep Power: 800

like i said before, stop talking about them and throw them on...lol...just bustin on ya...but get some sound clips when done...best way to take the old ones off is run the car for a while and shut it ff, then get to the bolts ASAP, bc they are easiest to remove when hot, take them off then...thats the easiest, from experience...

 
Rep Power: 875

Will my car even run without all the air tubes hookes up? I unbolted them all but need to move my car tomorow. I hope its ok.

 
Rep Power: 922

yea its fine. do you have emmisions in your town? if you dont have to have those hookups i would suggest taking them and the smog pump out. clean it up a lot.

 
Rep Power: 755

I'd say that was a good trade.

 
Rep Power: 875

I do have emmisions but im taking the air tubes out anyway and just leaving the pump in there. The guy who i got the headers from said it will pass without it anyway. He welded up all the holes for the tubes i just have to weld in a bung for my oxygen sensor

 
Rep Power: 0

good deal now u need the why pipe and all

 
Rep Power: 875

Got driver side manifold off. Had to cut the bolts going to the y-pipe. Is there anyway I can hook up my new headers to my stock y-pipe? I cant even fit it in its place and it hits the y-pipe. I guess I need to drop it. In the words of Paarman **** manifolds. haha

 
Rep Power: 0

Looks good but you will need to either really customize your YPipe or buy one that's made to hook up to those headers.