Need help
#2
#3
gription
hey guys i sent all the info but i think it went wrong so here i go again.
-3.7.3 gear
-bbk shorty headers
-bbk high flow cats
-flowmaster cat back 2.5
-welded sub frame connectors
-wheels are 5 spoke chrome mustang wheels
-motor-347 stroke with d-1sc supercharger (procharger)
-tranny-tko 600
the rest is stock. will axels ,rear end hold?
-3.7.3 gear
-bbk shorty headers
-bbk high flow cats
-flowmaster cat back 2.5
-welded sub frame connectors
-wheels are 5 spoke chrome mustang wheels
-motor-347 stroke with d-1sc supercharger (procharger)
-tranny-tko 600
the rest is stock. will axels ,rear end hold?
#4
The posi hold for a while but if you plan on launching with a sticky tire then I would do 31 spline axles and posi and girdle.A aluminum D/S will help absorb some twist better then a stocker steel one.Some good upper/lower control arms and a weld up the torque boxes.
#6
Im a fan of torque arm and panhard bars, with the right springs and shocks. And of course a nice sticky tire. You might also consider moving as much weight to the center or the rear of the car, ie: battery.
#8
hey guys i sent all the info but i think it went wrong so here i go again.
-3.7.3 gear
-bbk shorty headers
-bbk high flow cats
-flowmaster cat back 2.5
-welded sub frame connectors
-wheels are 5 spoke chrome mustang wheels
-motor-347 stroke with d-1sc supercharger (procharger)
-tranny-tko 600
the rest is stock. will axels ,rear end hold?
-3.7.3 gear
-bbk shorty headers
-bbk high flow cats
-flowmaster cat back 2.5
-welded sub frame connectors
-wheels are 5 spoke chrome mustang wheels
-motor-347 stroke with d-1sc supercharger (procharger)
-tranny-tko 600
the rest is stock. will axels ,rear end hold?
SS
Thread
Thread Starter
Forum
Replies
Last Post
Cyndi S
honda / acura
1
08-29-2007 09:53 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)