Rep Power: 742

hi guys iam new to this board i heard alot aboult it
taught i would drop by and share my new setup i been working this whinter

my ride is a 2001 integra type R #1282
mods are as follow
dart block
eagle rods
cp piston
micro polished crank
i have a fully ported head
custom grind camshaft (still witing for that might tune with type r cams)
reworked intake manifold
70 mm throttle body
equal lenght manifold
3inch down pipe
3inch thermal exhaust
gt35R with special trim
tial 48mm waste gate
tial 50mm blow off valve
custom intercooler
all runing off an aem ems

iam hopping for 500+whp
i will finish the car soon
iam sorry if i dont have picture i suck with computer
il get my cousin to help me post them wen i go to the dyno at the end of the winter

me and my father are also working on another project
i will get picture of that as well
it is a 97 cobra svt fully built from top to bottom
we got a baseline breck in tune and we hit 600whp @ 6k
with only 9 psi on the smaller blower with crazy belt slipage
the engine was built to rev at over 8k and handle over 28 psi
we are suppose to do a cog belt conversion wen we put the bigger blower on it we are shooting for 800whp but realy hoping for mid 900whp keep in mind these number are on c16 we are hoping to hit mid to low 9 sec pass
i will most likely have dyno vids of this

PL

 
Rep Power: 742

not mutch reply

 
Rep Power: 859

Photobucket.com for pics Just register, and upload pics. Then copy and paste the IMG code into the reply box here.

 
Rep Power: 742

i dont have a digital camera with me and iam kind of suck with computer
but you guys dont have to worry you wont miss on the action my cousin will
make a video compilation of both cars on the dyno