Hyundaitech 2001 santafe steering again
Guest
Posts: n/a
Hyundaitech 2001 santafe steering again
Jacked up again and took a look at what is actually moving.I t looks like
the passenger side,front drive axle shaft, is the only shaft doing the
moving in and out.
The movement is not at the wheel but inside the rubber boot that goes into
the tranny or front diff.?
Not sure of the terminology.
Could this be a ujoint or bearing gone?
Thanks for any help>
Zenox
the passenger side,front drive axle shaft, is the only shaft doing the
moving in and out.
The movement is not at the wheel but inside the rubber boot that goes into
the tranny or front diff.?
Not sure of the terminology.
Could this be a ujoint or bearing gone?
Thanks for any help>
Zenox
Guest
Posts: n/a
Re: Hyundaitech 2001 santafe steering again
If you can see the boot actually moving in and out, you've got play
elsewhere. If the bearing were bad, the most you'd get would be some
rocking of the shaft-- it wouldn't move in and out. I'd also expect you
to have one heck of a humming or rumbling noise when you drive.
The top of the wheel is pretty much fixed in place and won't move due to
the strut attachment. With the wheel jacked off the ground, grab the
bottom and see if you can pull it in and out. If you can, the problem is
likely in the ball joint. Look specifically to see if the control arm
pushes up and down when you move the bottom of the wheel in and out.
Similarly, when you rock the wheel from side to side, you should be able
to see the tie rod end joint move if that's where the issue is.
elsewhere. If the bearing were bad, the most you'd get would be some
rocking of the shaft-- it wouldn't move in and out. I'd also expect you
to have one heck of a humming or rumbling noise when you drive.
The top of the wheel is pretty much fixed in place and won't move due to
the strut attachment. With the wheel jacked off the ground, grab the
bottom and see if you can pull it in and out. If you can, the problem is
likely in the ball joint. Look specifically to see if the control arm
pushes up and down when you move the bottom of the wheel in and out.
Similarly, when you rock the wheel from side to side, you should be able
to see the tie rod end joint move if that's where the issue is.
Guest
Posts: n/a
Re: Hyundaitech 2001 santafe steering again
I will update you on what I find.
Thanks again
z
"hyundaitech" <notpublic@not.public.com> wrote in message
news:728d9dd17b79609148bad525c01db18d@localhost.ta lkaboutautos.com...
> If you can see the boot actually moving in and out, you've got play
> elsewhere. If the bearing were bad, the most you'd get would be some
> rocking of the shaft-- it wouldn't move in and out. I'd also expect you
> to have one heck of a humming or rumbling noise when you drive.
>
> The top of the wheel is pretty much fixed in place and won't move due to
> the strut attachment. With the wheel jacked off the ground, grab the
> bottom and see if you can pull it in and out. If you can, the problem is
> likely in the ball joint. Look specifically to see if the control arm
> pushes up and down when you move the bottom of the wheel in and out.
>
> Similarly, when you rock the wheel from side to side, you should be able
> to see the tie rod end joint move if that's where the issue is.
>
Thanks again
z
"hyundaitech" <notpublic@not.public.com> wrote in message
news:728d9dd17b79609148bad525c01db18d@localhost.ta lkaboutautos.com...
> If you can see the boot actually moving in and out, you've got play
> elsewhere. If the bearing were bad, the most you'd get would be some
> rocking of the shaft-- it wouldn't move in and out. I'd also expect you
> to have one heck of a humming or rumbling noise when you drive.
>
> The top of the wheel is pretty much fixed in place and won't move due to
> the strut attachment. With the wheel jacked off the ground, grab the
> bottom and see if you can pull it in and out. If you can, the problem is
> likely in the ball joint. Look specifically to see if the control arm
> pushes up and down when you move the bottom of the wheel in and out.
>
> Similarly, when you rock the wheel from side to side, you should be able
> to see the tie rod end joint move if that's where the issue is.
>
Thread
Thread Starter
Forum
Replies
Last Post
zenox
Hyundai Mailing List
2
Aug 1, 2007 01:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
